Pride Mobility Jet 7 Uživatelský manuál stáhnout pdf (Strana 18)

18 Basic Operation Instructions

VSI Controller www.pridemobility.com

cool down. When the temperature returns to a safe level, your power chair

resumes its normal operation.

FAULT CODES

The VSI controller is designed with the user’s safety as the prime consider-

ation. It incorporates many sophisticated self-test features which search for

potential problems at a rate of 100 times per second. If the VSI detects a

problem either in its own circuits or in the power chair’s electrical system,

it may decide to stop the power chair, depending on the severity of the prob-

lem. The VSI is designed to maximize the user’s safety under all normal

conditions. The table below identifies the individual fault codes. Fault codes

are displayed as a rapid flashing of the lights. If you encounter one of these

fault codes or experience any other problems with your power chair, contact

an authorized Pride Provider.

1 The batteries need charging or there is a bad connection to the batteries.

Check the connections to the batteries. If the connections are good, try

charging the batteries.

2 The left motor has a bad connection. Check the left motor connection.

3 The left motor has a short circuit to another connection. Contact your

authorized Pride Provider.

4 The right motor has a bad connection. Check right motor connection.

5 The right motor has a short circuit to another connection. Contact

your authorized Pride Provider.

Ripple side to The power chair is being inhibited by the off-board battery charger.

side of lights

7 A joystick fault is indicated. Make sure that the joystick is in the (center)

position before turning on the controller.

8 A controller system fault is indicated. Make sure that all connections

are secure and the batteries are fully charged.

9 The parking brakes have a bad connection. Check the parking brake

motor connections. Make sure the controller connections are secure.

10 An excessive voltage has been applied to the controller. This is usually

caused by a poor battery connection. Check the battery connections.

Flashing Diagnosis and Solution

Lights

1 2 ... 13 14 15 16 17 18 19 20

Žádné komentáře

Pride Mobility Jet 7 Uživatelský manuál Strana 18